User guide

Discharge Chute and Controls (Manual Crank)

14. Insert a pick or similar tool into the hole in the Gear

Shaft while removing the nut with a 9/16” wrench.

See Figure 8.30.

15. Remove the hex bushings, spring and washers from

the shaft.

To assemble the Remote Head:

1. Slide the Worm Gear onto the Gear Shaft so that the

alignment mark is facing and is aligned with the holes

in the gear shaft.

NOTE: Slide the gear onto the shaft from the side with the

holes.

Figure 8.30

Figure 8.31

Figure 8.32

Alignment Mark

Hole