Manual

Electric PTO Clutch
Left Hand Pulley
PTO Idler Bracket
(mounted on tractor)
Model1018
_Deck belt (Bottom)
Right Hand Pulley
(beneath belt guard)
Deck Idler Pulley
NOTE: Left hand belt cover not shown for"clarity.
Electric PTO Clutch
Center Pulley
Pigure 18
Self-Tapping Screws
Models1022&1024
_Deck / PTO Belt
Right Hand Pulley Right Hand Pulley
(beneath belt guard) (beneath belt guard)
Deck Idler Pulleys Self-Ta I _ing Screws
NOTE: Models 1022 & 1024 are equipped with a different size deck. However,the belt routing of each is the same.
Figure 19
ChangingTheTransmissionDriveBelt
NOTE: An air/impact wrench is needed to remove the
electric PTO and properly replace the drive belt.
All belts on your tractor are subject to wear and should
be replaced ifany signs of wear are present.
IMPORTANT: The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the drive belt on your tractor,
proceed as follows:
Remove the cutting deck as instructed earlier in this
section.
After disconnecting the battery cables, remove the
battery and battery tray from beneath the seat.
IMPORTANT: When removing the battery, disconnect
the NEGATIVE (Black) wire from it'sterminal first,
followed by the POSITIVE (Red) wire. Re-install in
reverse order.
22