Owner's manual

3-41

14. Remove the wheel shaft assembly, Part No.

611-0023, along with washer and spacer. See

Figure 3-102.

15. Remove the washer, spacer, gear idler assem-

bly, and spacer from the jackshaft. See Figure

3-103.

16. Lift the large spacer off the 10 tooth spur gear.

NOTE

Units produced prior to mid-1994: If rear wheel

drive is periodically lacking, the large spacer,

Part No. 750-0987, should be installed. See

Figure 3-104.

17. Lift the drive shaft assembly until the shift fork

is removed from the clutch collar. See Figure

3-105.

18. Remove the complete drive shaft assembly,

Part No. 611-0015, along with chain and

sprocket. See Figure 3-106.

Tillers.fm Page 41 Tuesday, February 19, 2002 1:28 PM