Owner's manual

3-39
3
2. Inspect and clean the tine shaft and wheel
shaft. Polish to remove any nicks or burrs. See
Figure 3-90.
3. Remove the 17—1/4-20 taptite screws. See
Figure 3-91.
4. Remove the 7/16-14 hex nut and bell washer.
See Figure 3-92.
5. Remove the reinforcement bracket and flat
washer. See Figure 3-93.
6. Remove the cover support. See Figure 3-94.
7. Remove the cover support brackets. See Fig-
ure 3-95.
8. Remove the cable support bracket. See Figure
3-96.
Tillers.fm Page 39 Tuesday, February 19, 2002 1:28 PM