Owner's manual

3-32
3. To remove reverse drive belt, lift up on small
idler pulley. Slip belt off outside sheave of
wheel chain case pulley. Remove belt from
two-step engine pulley. See Figure 3-73.
4. Loosen (do not remove) hex nut at the top of
wire belt keeper. See Figure 3-74.
5. Pull bottom of wire belt keeper out and then
upward, pivoting it away from the forward
engine pulley.
6. Lift forward drive belt off forward engine pulley
and remove. See Figure 3-75.
NOTE
When reassembling belts, be certain belts are
routed around all belt keeper pins.
7. Reassemble new belts, following instructions
in reverse order. See Figure 3-76.
Tillers.fm Page 32 Tuesday, February 19, 2002 1:28 PM