Owner's manual

3-28
10. To remove the wheel shaft assembly simply
pull the complete assembly out of the housing.
See Figure 3-61.
CAUTION
When reassembling, make certain the step
spacer and washers are positioned properly or
damage to the shaft assembly and/or bear-
ings will result. (Cupped side faces sprocket.)
11. Remove bearings from housing using an arbor
press as shown. See Figure 3-62.
NOTE
Both bearings, one plastic and one bronze,
must be pressed from the outside towards the
center of the housing.
Tillers.fm Page 28 Tuesday, February 19, 2002 1:28 PM