Owner's manual

5-37

NOTE

Shoulder of the bolt must go through both

sides of idler bracket assembly.

8. Reassemble belt cover and chute crank.

5-6.7 Drive Belt Removal. To remove drive belt,

proceed as follows:

1. Remove cotter pin which holds linkage rod to

idler bracket assembly.

2. Unhook extension spring from engine plate.

See Figure 5-62.

3. Remove drive belt from engine pulley and bot-

tom drive pulley.

4. Replace belt and reassemble in reverse order.

5-7. 33-INCH SNOW THROWER MODEL 960

(See Figure 5-63).

5-7.1 Model Specifications. For a summary of

specifications, see Table 5-3.

5-7.2 Drive clutch adjustment. Refer to Models 840

and 850 in paragraph 5-6.1.

5-7.3 Auger clutch adjustment. Refer to Models 840

and 850 in paragraph 5-6.1.

5-7.4 Shift rod adjustment. Refer to Models 840 and

850 in paragraph 5-6.3.

5-7.5 Changing the friction wheel. Refer to Models

840 and 850 in paragraph 5-6.4. See Figure 5-

55.

SNOW THROWER.fm Page 37 Wednesday, February 20, 2002 10:28 AM