Owner's manual

5-18
1. Remove three self-tapping screws from belt
cover using a 7/16 inch wrench. See Figure 5-
16.
2. Remove belt keeper by removing self-tapping
screw. A 9/16 inch wrench is required. See Fig-
ure 5-17.
3. Tip snow thrower forward so that it rests on
auger housing.
4. Remove two self-tapping screws in bottom
cover with a 1/2 inch wrench. Lift cover out.
See Figure 5-18.
5. Removing large shoulder bolt which acts as a
belt keeper by removing hex nut and lock
washer on the outside of frame assembly. A
9/16 inch wrench is required. See Figure 5-19.
6. Remove auger drive belt as follows:
a. Slip auger drive belt off engine pulley. See
Figure 5-20.
SNOW THROWER.fm Page 18 Wednesday, February 20, 2002 10:28 AM