Operator`s manual

Figure 7-8
CAUTION: Always use a replacement fuse with the
same amperage capacity as the blown fuse.
Tires
WARNING! Never exceed the maximum inflation
pressure shown on the sidewall of the tire.



maximum psi. Do not overinflate. Uneven tire pressure could
cause the cutting deck to mow unevenly.
Changing the Transmission Drive Belt


Cub Cadet dealer to have the transmission drive belt replaced.
Changing the Deck Belt
WARNING! 
ignition key before removing the cutting blade(s) for

using heavy gloves when grasping blades and
pulleys.
WARNING! The V-belts found on your tractor are
specially designed to engage and disengage safely.

not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present . To change or replace
the deck belt on your tractor, proceed as follows:
Remove the deck as instructed in the Cutting Deck section.
Remove the belt guards by removing the hex washer 2.

Remove the deck belt from around the three spindle 
pulleys and the two deck idler pulleys.
NOTE: The idler pulleys may have to be loosened, but not
removed, in order to remove the belt from around them.
Route the new belt as shown in Fig. 7-8.4.
Retighten idler pulleys, if loosened earlier.5.
Remount the belt guards removed earlier.6.
Belt Cover
Hex Washer
Screw
Idler Pulley
Figure 7-7
28 se c t i O n 7— se r v i c e