Operator`s manual

11se c t i O n 3 — as s e M b l y & se t -up
Lower Chute Crank Support Bracket Adjustment
If the spiral at the base of the lower chute crank isn’t fully
engaging with the notches in the lower chute assembly, the
support bracket can be adjusted inward or outward as follows:
1. Loosen, but do NOT remove the two hex nuts which secure
the support bracket to the snow thrower housing. See Fig.
3-16.
2. Adjust the support bracket inward or outward so that the
spiral is fully engaged in the notches on the chute before
retightening the hex nuts.
Spiral
Hex Nuts
Support
Bracket
Figure 3-16