Operator`s manual

Press primer bulb 10 times.
Move the choke
l
ever to Position 1.
M
ove the choke lever
to Position 2.
W
hile continuing to
squeeze the throttle
control, move the choke
lever to Position 3.
SQUEEZE and HOLD throttle
c
ontrol for ALL further steps.
Pull the rope
5 times.
P
ull the rope 3 to 5
times to start. Run
engine for 30-60
seconds to warm up.
C
ontinue warming for an
additional 60 seconds.
During this time the unit
may be used.
S
tand in the
s
tarting position.
DIDN’T START?
R
epeat the starting instructions.
If engine still fails to start, refer
t
o the Starting and Stopping
I
nstructions section of this
manual for additional starting
and troubleshooting information.
Quick Instructions
to Start the Unit
For complete instructions, refer to the
S
tarting and Stopping Instructions
s
ection of this manual.
Quick Instructions to
Assemble the Unit
For complete instructions, refer to the
A
ssembly Instructions section of this
m
anual.
5 X
IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Remove cotter pin from the clevis pin and slide
clevis pin out of tailpiece bracket. Slide the wheel
support bracket up or down to the desired tine
depth.Place the clevis pin through the aligned
h
oles and secure with clevis pin and cotter pin.
Tip the unit so that the back of the engine is in
a horizontal position. Remove the oil fill plug
from the crankcase and pour the entire bottle
o
f 4-cycle oil into the oil fill hole.
N
OTE: Do not mix gas and oil
Loosen the handlebar knobs and swing the
handlebars up into the operating position. Taking
c
are not to pinch any cables or wires, tighten the
k
nobs to secure the handlebars.
Shallower
D
eeper
NO ASSEMBLY TOOLS REQUIRED
769-07502 P00 09/11
Español — Page 11
English — Page 1
Français — Page 5
GC145
4-Cycle Cultivator
Operator’s Manual
NEED HELP? CALL 1-877-282-8684 IN U.S. OR 1–800–668–1238 IN CANADA

Summary of content (16 pages)