Manual

G730 35

RefertoFigure28

Disassembly

1. Remove all items previously discussed, in

their recommended order.

2. Remove the retaining ring (90).

3. Remove and discard the lip seal (96).

4. Remove the axle shaft (94) in the direction

of arrow.

5. Remove the bearing (95).

NOTE: Removethebearingfromtheaxleshaft

onlyifwornordamaged.

Inspection

1. Inspect the axle shaft for wear or damage.

Replace if necessary.

2. Inspect the bearing (95) for wear or damage.

Replace if necessary.

Assembly

1. Assemble items in reverse order of disas-

sembly.

NOTE: To protect the lip seal from possible

damagewheninstallingintothebore

andovertheaxleshaft,applyaprotec-

tive covering over the splines, sharp

cornersand/orkeywayoftheaxleshaft

(e.g.,cellophane,tape,etc.).

Figure 28, Axle Assembly

AXLE SHAFT (Main Housing)

Conguration “B” instructions listed below are for units with a serial number

on or after 9068YXXXX. For serial numbers before 9068YXXXX see previous

page.