Manual

34 G730

AXLE SHAFT (Main Housing)

RefertoFigure27

Disassembly

1. Remove all items previously discussed, in

their recommended order.

2. Remove the retaining ring (90).

3. Remove and discard the lip seal (96).

4. Remove the axle shaft (94) in the direction

of arrow.

5. Remove the bearing (95).

Inspection

1. Inspect the axle shaft for wear or damage.

Replace if necessary.

2. Inspect the bearing (95) for wear or damage.

Replace if necessary.

Assembly

1. Assemble items in reverse order of disas-

sembly.

NOTE: To protect the lip seal from possible

damagewheninstallingintothebore

andovertheaxleshaft,applyaprotec-

tive covering over the splines, sharp

cornersand/orkeywayoftheaxleshaft

(e.g.,cellophane,tape,etc.).

Figure 27, Axle Assembly

Conguration “A” instructions listed below are for units with a serial number

prior to 9068YXXXX. For serial numbers after 9068YXXXX see next page for

Conguration “B”.