Manual

24 G730
Figure 15, Axle Assembly
95
96
90
94
2
AXLE SHAFT (Side Housing)
Conguration “B” instructions listed below are for units with a serial number
on or after 9068YXXXX. For serial numbers before 9068YXXXX see previous
page.
RefertoFigure15
Disassembly
1. Remove all items previously discussed, in
their recommended order.
2. Remove the retaining ring (90).
3. Remove the lip seal (96) and discard.
4. Remove the axle shaft(94) and bearing(95)
in the direction of arrow.
NOTE: Removethebearingfromtheaxleshaft
onlyifwornordamaged.
Inspection
1. Inspect the axle shaft for wear or damage.
Replace if necessary.
2. Inspect the bearing (95) for wear or damage.
Replace if necessary.
Assembly
1. Assemble items in reverse order of disas-
sembly.
NOTE: To protect the lip seal from possible
damagewheninstallingintothebore
andovertheaxleshaft,applyaprotec-
tive covering over the splines, sharp
cornersand/orkeywayoftheaxleshaft
(e.g.,cellophane,tape,etc.).