Manual

20 G730
REQUIRED TOOLS
Miscellaneous Sockets
Hub Puller Small Internal Snap Ring Pliers
Flat Blade Screw Driver (2) 1/2”-3/8” Adapter
Torque Wrench 3/8” Deep
Air Impact Wrench 1-1/8” Deep
Rubber or Neoprene Mallet 1/4” Allen
Breaker Bar 3/4” Deep
Side Cutters/Snips 9/16” Deep
Needle Nose Pliers T-40 Torx Head
Large External Snap Ring Pliers 7/8” Deep
Large Internal Snap Ring Pliers
REQUIRED TORQUE VALUES
Item Description Torque Operation
4 Plug 9/16-18 (Metal) 110 -150 lb-in Oil Level Port Plug
7 Screw, Hex head 1/4-20 x 1.25” 105 - 155 lb-in Side Cover Screws
11 Plastic Plug 15 - 35 lb-in Fill Port Plastic Plug
12 Fitting, Metal 180 - 240 lb-in Breather Fitting
23 Filter 110 - 130 lb-in Oil Filter
24 Check Plug or Shock Valve 280 - 400 lb-in Center Section
25 Check Plug or Shock Valve 280 - 400 lb-in Center Section
27 Screw, Hex Head 3/8-16 x1.5 450 - 550 lb-in Center Section Screws
46 Torx Head Screw 5/16-24 x 1.00 230 - 310 lb-in RTN/FR Control Arm
47 Nut, Hex Lock 5/16-24 UNF 85 - 120 lb-in Friction Pack Nut
105 Screw, Hex Head 1/4-20 x .75 100 - 130 lb-in Filter Guard Screws
119 Hex Nut, 5/16 160 - 210 lb-in Damper Bracket Nut
122 Lock Nut, Hex 1/2-20 (Patch Insert) 540 - 660 lb-in Fan/Pulley Nut
123 Screw, 1/4-20 x .875 50 - 80 lb-in Fan Screws
134 HFHCS 1/4-20 x .75 100 - 130 lb-in Charge Plate Screws
142 SHCS 5/16-24 x 1 Patch 175 - 200 lb-in Neutral Arm Screw
142 Stud, Short 5/16-24 50-120 lb-in F/R Control Arm
175 Bolt, Hex Head 1/4 x 20 x 1 80 - 120 lb-in Brake Yoke Bolt
176 Bolt, Hex Head 1/4 x 20 x 2 80 - 120 lb-in Brake Yoke Bolt
192 Plug, 9/16-18 (Metal) 180 - 240 lb-in Fill Port Plug
193 Plug, 9/16-18 (Metal) 180 - 240 lb-in Drain Plug
194 Plug, 9/16-18 (Plastic) 15 - 35 lb-in Fill Plug
195 Plug, 9/16-18 (Metal) 180 - 240 lb-in Plug
196 Fitting, Metal 15 - 35 lb-in Breather Hose Fitting
TOOLS
As a general rule, use the low end of the torque spec on fasteners when reassembling the unit.
TORQUES