Manual

10 G730
191
12
190
FILTER AND FILTER GUARD
Refer to Figure 3
Disassembly
1. Remove the hex head screws (105), and
lter guard (106).
2. Remove the lter (23) and discard.
NOTE: Alwaysreplacethelterwhenpreform-
ing any internal maintenance to the
transaxle.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly. Refer to “Fluid Change
Procedures,” page 11, steps 3-5 for lter
installation instructions.
2. When tightening the fasteners, refer to the
table on page 20 for the required torque
values.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
3. Fill transaxle with oil.
Figure 3, Filter and Guard
Whenrellingthetransaxlewithoil,
removetheportplug(192),ifinstalled,
andplug(4).Filluntiltheoilreachesthe
lowerlipofoillevelcheckportonmain
housing.
23
106
105
Unitswillhaveinstalled,the
tting(5)ortheplug(192).
192
Oil Level Check Port Plug (4)