Operator`s manual

Belt Replacement

Reverse Drive Belt

Your tiller has been engineered with a belt made of special

material (Kevlar Tensile) for longer life and better performance. It



through you authorized service dealer.

Disconnect and ground the spark plug wire against the 

engine.

Remove the belt cover from the left side of the tiller by 2.

removing the two self-tapping screws and hex stop nut



Remove belt from transmission pulley and then from 



To reassemble the new belt, follow the instructions in 4.

reverse order. Be sure to place the wider side of the belt

against transmission and idler pulley while slimmer side



NOTE: Upon reassembly, make certain the belt is routed

over the idler pulley and inside of belt keepers by engine























Service