Use and Care Manual
11
OPERATION
O. GLOVE BOX
The glove box is a small storage area in the dash on the passenger
side of the utility vehicle.
P. INSTRUMENT CLUSTER
The instrument cluster contains:
1 TACHOMETER
2 PARKING BRAKE INDICATOR
3 BATTERY INDICATOR
4 OIL PRESSURE INDICATOR
5 ENGINE INDICATOR
6 EPS SYSTEM FAULT *
7 LEFT TURN SIGNAL
8 RIGHT TURN SIGNAL
9 HOUR METER
10 SPEEDOMETER
11 DIFFERENTIAL LOCK INDICATOR
12 2WD/4WD INDICATOR
13 GEAR INDICATOR
14 SEAT BELT INDICATOR
15 HAZARDS
16 HIGH BEAM INDICATOR
17 FUEL GAUGE
18 COOLANT TEMPERATURE
19 LOW BEAM INDICATOR
20 COOLANT OVERTEMP INDICATOR
* -- If equipped
OPERATION
First 50 Hours
How a new vehicle is handled and maintained determines the life
of the vehicle.
A new vehicle just off the factory production line has been, of
course, tested, but various parts are not fully aligned, so the
operator should pay more attention to operating the vehicle for
the first 50 hours at a slower speed and avoid excessive work
or operation until the various parts become “broken-in.” The
manner to which you handle the vehicle during the “breaking-in”
period greatly affects the life of your vehicle. Therefore, to
obtain the maximum performance and the longest life of the
vehicle, it is very important to properly break-in your vehicle. For
better handling a new vehicle, the following precautions should
be observed.
• Do not operate the vehicle at full speed for the first 50 hours.
D. HORN
The horn activates the horn under the hood when depressed.
E. HAZARD SWITCH
The hazard switch turns the hazards “ON” and “OFF.”
F. TURN SIGNAL SWITCH
The turn signal switch controls the turn signals and
activates the LH or RH turn signals.
G. 12V POWER OUTLET
The 12V power outlet is used for the convenience of plugging in
accessories that require a power source with a maximum load
of 5A at 12V.
H. BRAKE PEDAL
The brake pedal is used to slow down/stop the utility vehicle.
I. GAS PEDAL
The gas pedal is used to control the speed of the utility vehicle.
J. 2WD/4WD SWITCH
The 2WD/4WD switch is used to switch between 2WD
and 4WD.
K. FRONT AXLE DIFFERENTIAL SWITCH
The front axle differential switch can “LOCK” or
“UNLOCK” the front axle differential.
L. REAR AXLE DIFFERENTIAL SWITCH
IF EQUIPPED
The rear axle differential switch can “LOCK” or
“UNLOCK” the rear axle differential.
M. SHIFT LEVER
The shift lever changes the gears of the utility vehicle
between park (“P”), reverse (“R”), neutral (“N”), high (“H”)
and low (“L”).
N. PARKING BRAKE LEVER
The parking brake lever activates the utility vehicle’s
parking brake.