Product Manual

Maintenance & Adjustments

Maintenance

General Recommendations

• Always observe safety rules when performing any

maintenance.

• The warranty on this chipper/shredder vacuum does not

cover items that have been subjected to operator abuse or

negligence. To receive full value from warranty, operator

must maintain the equipment as instructed here.

• Changing of engine-governed speed will void engine

warranty.

• All adjustments should be checked at least once each

season.

• Periodically check all fasteners and make sure these are

tight.

WARNING: Always stop engine, disconnect spark

plug, and ground against engine before performing

any type of maintenance on your machine.

Lubrication

1. Lubricate each w heel sho ulder screw (rear whe el) and pivot arm

axle (front wheel) once a season with light oil.

2. Lubricate the pivot points of the nozzle height adjustment

levers once a season with light oil.

3. Lubric ate the locki ng rod with light oi l to ease the applic ation of

attaching on or removing bag.

4. Lubricate the nozzle/hose vac lever on top of the nozzle once a

season with light oil. See Fig. 6-1.

5. Follow the separate engine manual packed with your unit for

lubrication instructions.

Equipment Care

• Clean the chipper/shredder vacuum thoroughly after each

use.

• Wash bag periodically with water. Allow to dry thoroughly

in shade.

• If the flail screen becomes clogged, remove and clean as

instructed below.

NOTE: Cleaning with a forceful spray of water is not

recommended as it could contaminate the fuel system.

Figure 6-1