Operator`s manual

Assembly & Set-Up
3
8
Tighten star knobs securing lower handle to handle 2.
brackets. See Fig. 3-2. Make certain the lower handle is
seated securely into the handle mounting brackets.
Contents of Carton
One Battery Mower• One Grass Catcher• One Side Discharge Chute•
One Operator’s Manual• One Battery• One Charger•
Assembly
Handle
Remove any packing material which may be between 1.
upper and lower handles.
Loosen each hand knob found on the inside of the a.
upper handle.
Gently lift and pivot the upper handle into the b.
operating position as shown in Fig. 3-1.
Remove star knobs from handle mounting brackets c.
and secure the lower handle onto the handle
brackets by placing the lower hole of the lower
handle onto the pins of the handle brackets.
Secure the upper handle and lower handle by d.
tightening the hand knobs. Each carriage bolt must
be seated properly into the square hole found in the
plastic connector.
Figure 3-1
Figure 3-2