Operator`s manual

ManualsBrandsCub Cadet ManualsTrimmerCC4105

Contents of Crate

  

 

Manual



Manual

Tractor Preparation

Remove the upper crating material from the shipping pallet, and

cut any bands or tie straps securing the tractor to the pallet.

Use the lift handle to raise the deck to its highest position.

Engage the transmission bypass rods on each side of the

tractor; then carefully roll the tractor off the shipping pallet.



transmission) are located beneath the frame platform, just inside



Remove the deck wash system nozzle adapter and oil drain tube

from the manual bag and store for future use.

Install Operator’s Seat

To install the seat proceed as follows:

NOTE: The seat is shipped with the seat switch and seat pan

attached.

Cut any straps securing the seat assembly and the drive 

control levers to the tractor. Remove any packing material.

NOTE: 

seat and the seat switch.

Pull Out Bypass

Rod Then Lower

Into Slot

Keyhole Slot

RH Transmission

Bypass Rod

Figure 3-1

Remove the two shoulder bolts and lock nuts in the seat 2.



Rotate the seat into position and secure the seat into place 

with the previously removed shoulder bolts and lock nuts.





Wire Harness

Seat Bracket

Shoulder

Bolts

Lock

Nuts

Figure 3-2