Use and Care Manual
20
PRODUCT CARE
MAINTENANCE SCHEDULE
WARNING
Before performing any type of maintenance/service,
disengage all controls and stop the engine. Wait until
all moving parts have come to a complete stop. Allow
the engine to cool. Disconnect spark plug wire(s) and
negative battery cable to prevent unintended starting.
Always wear safety glasses during operation or while
performing any adjustments or repairs.
IMPORTANT! It is important to consult the specific Engine
Operator’s Manual included with this machine for detailed
engine maintenance procedures and intervals.
NOTE: This Operator’s Manual covers several models. Riding
mower features may vary by model. Not all features in this
manual are applicable to all riding mower models and the riding
mower depicted may differ from yours.
POSTOPERATION RIDER CARE
After each operation of the rider, the following procedures
should be implemented to extend the life of your rider and
ensure safe operating conditions.
WARNING
Failure to follow these recommendations may result
in serious injury to yourself or others and may cause
damage to the rider.
Cleaning the Underside of the Deck
DECK WASH SYSTEM IF EQUIPPED
Your rider’s deck may be equipped with a water port on its
surface as part of its deck wash system.
Use the deck wash system to rinse grass clippings from the deck’s
underside and prevent the build-up of corrosive chemicals.
Complete the following steps AFTER EACH MOWING:
1. Drive the rider to a level, clear spot on your lawn, near enough
for your garden hose to reach.
Follow the maintenance schedule given below. This chart
describes service guidelines only.
Before
Each Use
Every
10 Hours
Every
25 Hours
Every
50 Hours
Every
100 Hours
Prior to
Storing
Check/Clean Engine Intake Screens & Cooling Fans *
P P
Check/Clean Exhaust Manifold,
Muffler Pipe & Muffler Shields *
P P
Check/Clean Hood/Dash Panel Louvers *
P P
Check/Clean Top & Underside of Deck, Under & Around
Spindle Covers & Belt Area *
P P
Check/Clean Around Fuses, Wiring &
Wiring Harnesses *
P P
Check/Clean Around Transmission, Axle & Fans *
P P
Check Engine Oil Level
P P
Check Air Filter for Dirty, Loose or Damaged Parts
P
Clean & Re-oil Air Filter’s Foam Pre-cleaner
(If equipped)
P
Replace Air Filter Element
P
Change Engine Oil & Replace Oil Filter (If equipped)
P
Lube Front Axles & Rims
P P
Check Spark Plug Condition & Gap
P P
Replace Fuel Filter
P
* -- Perform more often in dry conditions and/or when mulching.