Use and Care Manual
14
OPERATION
Push the throttle control handle forward to increase the engine
speed. The riding mower is designed to operate with the throttle
control in the FAST position (full throttle) when the mower
deck is engaged.
Pull the throttle control handle rearward to decrease the
engine speed.
B. IGNITION SWITCH MODULE
WARNING
Never leave a running machine unattended. Always
disengage PTO, set parking brake, stop riding mower,
and remove the key to prevent unintended starting.
The ignition switch module is located on the left fender of the
riding mower seated in the operator’s position, adjacent to the
throttle/choke control or throttle control.
Ignition Switch Module with Reverse Caution
Mode (If equipped)
To start the engine,
insert the key into
the ignition switch
module and turn
clockwise to the
START position.
Release the key
into the NORMAL
MOWING MODE
position
once the engine
has fired.
To stop the engine,
turn the ignition
key counter-
clockwise to the STOP position.
NOTE: This Operator’s Manual covers several models. Riding
mower features may vary by model. Not all features in this
manual are applicable to all riding mower models and the riding
mower depicted may differ from yours.
NOTE: All references in this manual to the left or right side and
front or back of the riding mower are from the operating position
only. Exceptions, if any, will be specified.
A. THROTTLE/CHOKE CONTROL OR THROTTLE
CONTROL LEVER IF EQUIPPED
Throttle/Choke Control Lever (If equipped)
The throttle/choke control lever is located on the left fender. This
lever controls the speed of the engine and, when pushed all the
way forward, past the detent position, closes the choke for cold
starting. When set in a given position, the throttle will maintain
a uniform engine speed.
NOTE: When operating the riding mower with the cutting deck
engaged, be certain that the throttle/choke control is always in
the FAST position.
Throttle Control (If equipped)
The throttle control is located on the left side of the left fender.
When set in a given position, a uniform engine speed will
be maintained.
FAST
SL OW
FAST
SLOW
A
B
L
E
O
P
N
*
G
D
M
K
J
C
N
*
A
B
L
F
P
N
*
I
K
J
H
N
*
M
(I)
B
F
P
I
K
J
H
N
*
M
Hydro Transmission 30” 6-Speed Transmission 24” 6-Speed Transmission
*--Refer to oil fill cap for location of your oil fill cap.
Figure 19