Use and Care Manual

10
SET-UP
ATTACHING THE SEAT IF NECESSARY
If the seat for your riding mower was not attached at the factory,
follow the applicable instructions below to attach it.
1. Remove the shoulder bolts (a) and lock nuts (b) from the
seat mounting bracket (c) included in your hardware pack
(Figure 6).
c
a
a
b
b
Figure 6
2. Remove the two self-tapping bolts (a) factory-installed on
the riding mower (Figure 7).
a
a
Figure 7
3. Align the seat bracket (a) in place over the holes from where
the self-tapping bolts (b) were removed (Figure 8).
b
b
a
Figure 8
4. Using a 1/4” drive ratchet with a 3/8” socket, secure the seat
bracket (a) with the self-tapping bolts (b) removed in Step
2 (Figure 8).
CAUTION
Do not use any type of power tool (e.g. impact gun or
electric drill with nut driver attached) when tightening
the self-tapping bolts to attach the seat bracket.
5. Position the seat assembly over the seat mounting bracket,
aligning the holes provided.
6. Install the two shoulder bolts (a) and lock nuts (b) removed
from the seat mounting bracket (c) in Step 1 (Figure 9).
NOTE: Make sure that the bolt’s shoulder is completely recessed
into the seat bracket when securing the lock nut (Figure 9 inset).
a
a
b
b
b
c
c
a
Figure 9