SDS

Material Safety Data Sheet
Report No.:STRD1405012S Page 8 of 10
Shenzhen SEM.Test Technology Co., Ltd.
1/F, Building A, Hongwei Industrial Park, Liuxian 2nd
Road, Bao'an District, Shenzhen, P.R.C. (518101)
Do not allow undiluted product or large quantities
of it to reach ground water, water course or
sewage system.
Anticipated behavior of a chemical product in
environment/possible environmental
impace/ecotoxicity
Not Available
Mobility in soil Not Available
Persistence and Degradability Not Available
Bioaccumulation potential Not Available
Other Adverse Effects Not Available
Section 13 – Disposal Considerations
Product disposal recommendation: Observe local, state and federal laws and regulations.
Packaging disposal recommendation: Be aware discarded batteries may cause fire, tape the battery
terminals to insulate them. Don’t disassembly the battery. Completely discharge containers (no tear
drops, no powder rest, scraped carefully). Containers may be recycled or re-used. Observe local,
state and federal laws and regulations.
The potential effects on the environment and human health of the substances used in batteries and
accumulators; the desirability of not disposing of waste batteries and accumulators as unsorted
municipal waste and of participating in their separate collection so as to facilitate treatment and
recycling;
Section 14 – Transport Information
This report applies to by sea, by air and by land;
The Lithium-ion Battery (model: 17256-3ltd) tested according to the requirements of the UN
manual of tests and Criteria, Part III, subsection 38.3;
The Lithium-ion Battery according to Section II/Section IB of PACKING INSTRUCTION 965, or
Section II of PACKING INSTRUCTION 966～967 of the 2014 IATA Dangerous Goods regulations
55
th
Edition may be transported. and applicable U.S. DOT regulations for the safe transport of
Lithium-ion Battery.
Lithium-ion Battery was protected so as to prevent short circuits. This includes protection against
contact with conductive materials within the same packaging that could lead to short circuit;
Cell and batteries offered for transport must be packed in inner packaging’s that completely
enclose the cell or battery; to provide protection from damage or compression to the batteries, the
inner packaging’s must be placed in a strong rigid outer packaging;
The packaging shall be adequate to avoid mechanical damage during transport, handling and
stacking. The materials and pack design shall be chosen so as to prevent the development of
unintentional electrical conduction, corrosion of the terminals and ingress of moisture.