User guide

22” Trimmer Mower

Spindle

NOTE: The spindle can not be serviced, and must be

replaced as a unit if it gets damaged.

See Figure 6.

NOTE: The cutting height is adjusted by sliding the disc

that the trimmer line is attached to up or down the

spindle shaft.

• The disc is held in position by two wing nuts, that

must be loosened before making a height adjust-

ment, and re-tightened to hold that adjustment.

• The skid assembly remains fixed, and the disc

moves in relation to the skid assembly.

• The wing nuts cannot be removed from their

studs: the threads are peened.

1. Disconnect and ground the spark plug wire.

2. Remove the nuts from the four carriage bolts that

hold the deflector to the trimmer base, using a 7/16”

wrench.

See Figure 7.

3. Rotate the deflector so that the wide part of the cen-

ter hole in the deflector will fit past the spindle. See

Figure 8.

4. Remove the deflector.

Figure 6

spindle

trimmer line disc

wing nut

Figure 7

nuts

Figure 8

Removing the deflector.