Use and Care Manual

13
The battery charger is not plugged in Plug the battery charger into a 120V 60hz AC source
The battery charger is not firmly assembled
Disconnect and then reassemble the battery charger. Refer to
Assembling the Battery Charger.
The battery is not fully inserted into the battery charger
Remove and then reinsert the battery into the battery charger
completely
The battery is too hot Allow the battery to cool for 30 minutes before charging
The battery and/or battery charger are no longer functional Refer to the Warranty section for replacement information
TROUBLESHOOTING
The battery lacks sufficient charge Charge the battery completely
The battery is not installed correctly Remove and reinstall the battery
The lock-off button was not engaged
Press and hold the lock-off button before squeezing the throttle
control
PROBLEM SOLUTION
The battery is not fully charged Charge the battery completely
The battery and/or battery charger are no longer functional Refer to the Warranty section for replacement information
THE BATTERY WILL NOT CHARGE
THE BATTERY DIES QUICKLY
THE MOTOR WILL NOT RUN