Service manual

4 X 2 Drive System - (Steel Bed)

12.6. Lift the reverse gear off of the intermediate shaft.

See Figure 12.6.

NOTE: The reverse gear has smaller O.D. and

larger I.D. than the forward gear.

NOTE: The recessed side faces the shift collar.

12.7. Lift the shift collar off of the intermediate shaft

together with the shift rod assembly. The pin on

the shift rod assembly should disengage from

th e slot in the shift actu ato r as it is lift ed out.

See Figure 12.7.

Figure 12.6

Intermediate

Reverse Gear

Shaft

Recessed

Side

Shift Collar

Figure 12.7

Shift Rod Assembly

Shift Actuator

12.8. Remove the intermediate shaft. See Figure 12.8.

12.9. Lift the forward gear out of the housing. The for-

ward gear has a smaller I.D. and a larger O.D.

than the reverse gear does. See Figure 12.9.

NOTE: The recess in the forward gear faces up,

toward the shift collar, the flat side faces the

housing.

12.10.Remove the thick (.110” thick) thrust washer

from case. It may sometimes remain stuck to the

forward gear, because of vacuum and oil adhe-

sion.

Figure 12.8

Intermediate Shaft

Forward Gear

(Recessed Side

Faces Shift Collar)

Figure 12.9

.110 Thick Thrust Washer

www.mymowerparts.com

K&T Saw Shop 606-678-9623 or 606-561-4983