Operator`s manual

Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
NOTE: For detailed information on all engine controls, refer to
the separate Tecumseh Engine Operator’s Manual.
Speed Selector Shift Lever
The speed selector shift lever is located in the right
side of the handle panel and is used to determine
ground speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
Choke Control
The choke control is found on the rear of the engine and is
activated by rotating the knob counter-clockwise. Activating the
choke control closes the choke plate on the carburetor and aids
in starting the engine.
Key
The key is a safety devise. It must be fully inserted in order for the
engine to start. Remove the key when the snow thrower is not in
use.
Important: Do not turn the key in an attempt to start the
engine. Doing so may cause it to break.
Figure 4-1
Chute Assembly
Augers
Auger
Housing
Skid Shoes
Clean-out Tool
Drive Control
Auger Control
Primer
Choke
Throttle
Recoil Starter
Handle
Oil Drain
Electric
Starter Outlet
Electric
Start
Button
Chute
Directional
Control
Wheel Steering Control
Headlight
Oil Filler
Cap/Dipstick
Key
Gas Cap
Speed Selector
Shift Lever
Two-way Chute Control™
Controls and Features
4
13