Service manual

CLUTCH
3-3
D569-W02 May-2003
1. TROUBLESHOOTING
Clutch slip
Clutch disconnection
abnormal
Starting is not smooth
Clutch noise
Clutch vibration
Clutch gets connected
suddenly
Symptom
Clutch pedal play too small
Clutch disc facing worn
Grease or oil on clutch disc facing
Distortion or damaged in clutch pressure plate
and flywheel
Missing or feeble spring of clutch pressure plate
Excessive clutch pedal defection
Grease or oil on clutch disc facing
Vibration or distortion in clutch disc
Rust developed in clutch disc hub and shaft
splice part
Clutch lever deformation, defective adjustment
Abrasion and breakage in release bearing
Fixation of clutch disc and flywheel or pressure
plate, rust developed
Foreign substance intermixed in clutch
Grease or oil on clutch disc facing
Loosened riveting in clutch disc facing
Distortion or damage in clutch disc, pressure
plate and flywheel
Defective adjustment of clutch lever
Missing or feeble spring of pressure plate
Rust or wear in clutch disc hub and shaft spline
part
Wear and Abrasion in release bearing
Wear in clutch disc hub and shaft spline part
Missing torsion spring of clutch disc
Clutch disc damaged
Bending in shuttle shaft or PTO drive shaft
Defective dynamic balance in clutch assembly
Damages on other clutch related parts
Grease or oil on clutch disc facing
Distortion in clutch pressure plate and flywheel
Damage on torsion spring of clutch disc
Provable Causes
Adjust
Replace
Clean or replace
Correct or replace
Replace
Adjust
Clean or replace
Replace
Remove rust or replace
Adjust or replace
Replace
Remove rust or replace
Clean
Clean or replace
Replace
Correct or replace
Adjust
Replace
Remove rust or replace
Replace
Replace
Replace
Replace
Replace
Replace
Replace
Clean or replace
Correct or replace
Replace
Solution
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983