Service manual

TRANSMISSION
4-29
D615-W02 May-2003
615W448A
615W447A
10.2 SECOND STAGE (DISCONNECTION OF
PROPULSION SHAFT CASE)
1. Loosen clutch release fork (1) locking bolt (2) and
pull out main clutch lever (3).
2. Disconnect clutch release hub (4) and release bear-
ing (7).
3. Loosen propulsion shaft case (5) attaching bolt (6)
and using M6 service bolt (two), disconnect propul-
sion case.
(When reassembling)
• Apply the slip of propulsion case and release hub
with grease.
• Wipe out foreign matters or oil from the contacted
surface of clutch housing and propulsion shaft case
and apply with sealing agent.
Sealing agent Three bond 1208D or equivalent
(1) Clutch Release Fork (5) Propulsion Shaft Case
(2) Bolt With Washer (6) Bolt With Washer
(3) Main Clutch Lever (7) Release Bearing
(4) Clutch Release Hub (8) Service Bolt
Sect. Spec. Tightening Torque
Tightening bolt, nut M8 23.5 ~ 27.4 N·m
2.4 ~ 2.8 kgf·m
17.3 ~ 20.2 lbf·ft
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983