Operator`s manual

Assembly

Remove all loose parts before assembling.

Handle Assembly

Place the shift lever in the Forward-6 position1.

Observe the lower rear area of the snow thrower to be sure 2.

both cables are aligned with roller guides before pivoting

the handle upward. Pivot the handle upward. See Fig. 3-1.

NOTE: Make certain the cables are seated properly in the

roller guides. See Fig. 3-2.

Secure the handle by tightening the plastic knob located 3.

on both the left and right sides of the handle. Remove

and discard any rubber bands, if present. They are for

packaging purposes only.

Contents of Carton

One Snow Thrower• Two Replacement Auger Shear Pins• One Chute Assembly•

One Chute Control Rod• One Product Registration Card• One Engine Operator’s Manual•

One Snow Thrower Operator’s •

Manual

Figure 3-1

Chute Control Head

Chute

Chute Support

Bracket

Chute Base

Figure 3-3

Figure 3-2

Chute Assembly

Remove hairpin clip, wing nut and hex screw from chute 1.

control head and clevis pin and bow-tie cotter pin from

chute support bracket. See Fig. 3-3.

Assembly & Set-Up