MSDS

7. HANDLING AND STORAGE
Precautions to be taken in handling and storage:
Keep away from heat, sparks and open flame. - No smoking. Keep container closed when not in use. Do not store above
120 degrees F. (49 degrees C). Based on flash point and vapor pressure, suitable storage should be provided in
accordance with OSHA regulation 1910.106, Ontario OH&S regulation 851 section 22. Empty containers may contain
product residue, including flammable or explosive vapors. Do not cut, puncture or weld on or near container. All label
warnings must be observed until the container has been commercially cleaned or reconditioned. If the product is used
near or above the flashpoint, an ignition hazard may be present. Activities, uses, or operations which liberate vapor (such
as mixing or free fall of liquids) may also present an ignition hazard. Please ensure containers and other interconnected
equipment are properly bonded and grounded at all times.
8. PERSONAL PROTECTIVE EQUIPMENT AND EXPOSURE CONTROLS
Personal Protective Equipment
Eye and face protection:
Wear safety glasses or goggles to protect against exposure.
Skin protection:
Appropriate chemical resistant gloves should be worn.
Other Personel Protection Data:
Usual industrial work clothes.
Respiratory protection:
If exposure cannot be controlled below applicable limits, use the appropriate NIOSH approved respirator such as an air
purifying respirator with organic vapor cartridge and dust/mist filter. Consult the respirator manufacturer's literature to
ensure that the respirator will provide adequate protection. Read and follow all respirator manufacturer's instructions.
Ventilation
Use only in well-ventilated areas. Ensure adequate ventilation, especially in confined areas. Ovens used for curing should
contain a fresh air purge to prevent vapours from accumulating and creating a possible explosive mixture. Where the
product is used in a hazardous classified area, use explosion-proof electrical/ventilating/lighting/equipment.
Exposure Guidelines
OSHA Permissible Exposure Limits (PEL's)
Ingredient Name
CAS-No.
Approx.
Weight %
TWA (final) Ceilings limits (final) Skin designations
DIMETHYL KETONE-
EXEMPT SOLVENT
67-64-1
35 - 40 1000 ppm TWA
2400 mg/m
3
TWA
PROPANE
74-98-6
10 - 15 1000 ppm TWA
1800 mg/m
3
TWA
BUTYL ACETATE
123-86-4
10 - 15 150 ppm TWA
710 mg/m
3
TWA
TITANIUM DIOXIDE
13463-67-7
5 - 10 15 mg/m
3
TWA dust
total
ACGIH Threshold Limit Value (TLV's)
Ingredient Name
CAS-No.
Approx.
Weight %
TWA STEL Ceiling limits Skin
designations
DIMETHYL KETONE-
EXEMPT SOLVENT
67-64-1
35 - 40 500 ppm TWA 750 ppm STEL
Product ID: 160.7884022.076
Page 4 / 9