Manual

10
Figure 11
WARNING: Do not exceed 1,000 lb. in the cargo box.
Tailgate
The tailgate can be hinged at the top or the bottom
depending on how you release the holding pins. If you
pull out on the two top pins, the tailgate will swing down.
If you pull out the two bottom pins, you can pivot the
tailgate upwards.
SECTION 3: OPERATING YOUR UTILITY VEHICLE
WARNING: This is an off-road utility vehicle
and it should not be operated on public
highways. Know and comply with all laws and
regulations governing the use of off-highway
vehicles in your area.
IMPORTANT: Before starting the engine read this
manual and the Kohler Engine manual thoroughly to
understand all instructions.
WARNING: Do not run an engine in an
enclosed area. Move the vehicle to an
outside area before running the engine.
IMPORTANT: Tires are shipped over-inflated. Reduce
inflation pressure in all tires to approximately 5 -6 psi.
Check Neutral Safety Switch
• Sit in the operator’s seat and place key switch in
STOP position.
• Lock parking brake and move gearshift lever to the
forward position.
• Move key switch to START position. The engine
should NOT crank.
• Turn key switch to STOP and move gearshift lever
to the reverse position.
• Move key switch to START position. The engine
should NOT crank.
• Turn key switch to STOP.
• Keep engine compartment clean and be sure fan or
flywheel screens remains installed and clean.
Starting Engine
• Sit in the operator’s seat and place key switch in
STOP position.
• Move gearshift to the N (Neutral) position and lock
parking brake.
• Pull out the choke knob if engine is cold.
• Turn key to the START position.
• Release key to the RUN position when engine
starts.
• If engine does not start, wait a few seconds and
repeat procedures.
• After engine starts, push in choke knob.
IMPORTANT: DO NOT run the starter continuously for
more than 5 seconds, otherwise the battery may
discharge quickly.
NOTE: If engine surges after starting while idling or
driving at a low speed, apply choke as needed until
engine has warmed up.
IMPORTANT: Do not operate the engine under full load
until engine has warmed up.
Stopping Engine
• To stop utility vehicle, release accelerator pedal
and depress brake pedal until vehicle comes to a
complete stop.
• Move gearshift lever to N (Neutral) position.
• Lock parking brake and turn key switch to STOP
position.
• Remove the key when not in use.
Driving Utility Vehicle
• Make sure front wheels are turned to the desired
direction.
• Depress brake pedal to release parking brake.
• To avoid damaging transmission, depress brake
pedal fully and make sure vehicle is completely
stopped before shifting into Forward or Reverse.
Cargo Box