Owner`s manual

93
Technician’s Service Test
11. What is covered in the Electronic Governor TechTips?
a. Blink code information
b. Mechanical checks
c. Troubleshooting procedures
d. All of the above
 .RKOHU3/86KDVDGGHGPDQ\KHOSIXOIHDWXUHVWKLV\HDUWKH\DUH
a. Crankshaft illustrations and dimensions, carburetor repair kits when you enter a carburetor part number.
b. New service and parts bulletins posted for one month on “”News Flash””, Fast Moving Parts
c. Idle & High Speed RPM for each spec, search by description or part number.
d. All of the above.
 :KDWLVWKHLQWHUQHWDGGUHVVRI.RKOHU¶VQHZZHEEDVHG:DUUDQW\3URFHVVLQJ6\VWHP"
a. http://enginewarranty.kohlerplus.com
b. www.enginewarranty.kohlernet.com
c. www.google.com
d. http://enginewarranty.kohlernet.net
 +RZPDQ\)DFWRU\7UDLQLQJ6FKRROVDUHDYDLODEOHLQ"
a. 8
b. 4
c. 12
d. 6
 7KH&9WZLQFDUEXUHWRUVROHQRLGNLW6VKRXOGLQFOXGHDSOXJLQVWDOOHGLQWKHHQG6RPHNLWVZHUHVHQW
ZLWKDMHWLQVWHDG<RXPXVWWUDQVIHUWKHRULJLQDOMHWZK\"
a. The plug is no longer available.
b. The included jet is only used with E85 fuel.
c. The included jet is too small and performance will be affected.
d. The included jet is too large but can be repaired with solder and a 1/16” drill.
 ,QIRUPDWLRQUHJDUGLQJZKHWKHUDQHQJLQHLV(3$RU&$5%FRPSOLDQWRUQRWFDQEHIRXQG
a. on the information tag located on the engine.
b. on the information tag located in the left door jam of the tractor.
c. stamped into the cylinder block near the starter.
 G RQWKHLQIRUPDWLRQWDJORFDWHGRQWKHRLO¿OWHU
 :KHQHQWHULQJDSDUWQXPEHULQWKHQHZ.RKOHUZHEEDVHGZDUUDQW\V\VWHP\RX
a. must use dashes in the part number.
b. must always use spaces in the part number.
c. do not need to enter a part number. The warranty system knows what parts you used.
d. must never use spaces in the part number.
 7KHSURFHVVXVHGWRZHOGWKHWDQNKDOYHVWRJHWKHURQWKH;7HQJLQHKDVOHIWKDLUOLNH¿EHUGHEULVLQWKHWDQN
7HFKQLFDOÀDVK.(.VXJJHVWVWKHIROORZLQJUHSDLU
a. Blow compressed air in from the outlet side to force the debris out of the inlet side.
b. Use a .078 in. (2.2 mm) stiff wire probe and push it into the tank fuel outlet.
c. Use a .078 in. (2.2 mm) drill bit to clean the tank outlet and make sure you go in at least 2 in. (50.8 mm)
d. Blow compressed air into the tank from the inlet side to force it out the outlet side.
 :KDWHQJLQHKRUVHSRZHUUDQJHLVWKHQHZFRPPHUFLDO(),V\VWHPFXUUHQWO\GHVLJQHGIRU"
a. 27 to 40 hp
b. 3.5 to 30 hp
c. 20 to 42 hp
d. 19 to 41 hp
 7KH&RXUDJH7ZLQFDPVKDIWVZHUHFKDQJHGWR
 D EHWWHU¿WWKHFUDQNVKDIWJHDU
b. reduce noise, weight and cost.
c. allow easier starts during winter operation.
d. prevent tooth failure of the gear.