Owner`s manual
86
Bulletins, Etc.
6
Kohler Electronic Governor Troubleshooting Chart
Turn off key switch
Do Not Touch the Digital Linear Actuator (DLA)
NOTE: The DLA is not a solenoid. It is a
precision electronic motor. Do not exert
force to the center clevis shaft!
Visually inspect the DLA and Linkage. Figure 1 or 4
Arm and boot installation as follows, Refer to Figure 1, 4, or 5.
1. Remove the DLA from control assembly.
2. Pull clevis shaft completely out of DLA.
3. Reinstall the boot on the DLA if required.
'R1RWSXVKRUIRUFHWKHFOHYLVVKDIWLQWRERG\LWPXVW¿UVWEHWKUHDGHGDQGFRUUHFWO\DOLJQHG
Improper installation can permanently damage the DLA.
5. Lightly insert clevis shaft into body of DLA.
6. Thread 3 full turns or until you feel the internal key touch. Flat surface clevis should be in
alignment with DLA mounting holes.
7. Firmly push DLA to bottom.
8. Connect clip.
9. Connect wire.
&RQ¿UPWKHIROORZLQJ
1. Clevis shaft and boot in place
2. Clip attached
3. DLA wire attached
Fail if
Pass if
Fail
Pass
Clevis shaft and boot are out of the DLA
Test the control system of the equipment. Refer
to the Equipment Manufacturer’s diagnostic
procedures for the control system.
Go to 12 Volt "Power Test"
on next page.
Start/test run unit for engine speed control operation.