Owner`s manual

Bulletins, Etc.

Figure 3. Governor Control Unit Locations.

Governor Control Unit

Actuator

Clevis Shaft

Rubber Boot

Figure 5. Exploded View of Clevis Shaft.

Keyway

Keys

Clevis

Mounting Holes

Mechanical Checks

The DLA must be in the fully retracted position during

¢ǯȱȱȱȱȱĴȱȱȱȱ

not be achieved if the DLA is partially extended when

assembled. Loosen the two DLA mounting plate screws

ȱȱȱȱȱȱȱǯȱȱȱĴȱ

linkage centered in the U-Clip or secured with a retaining

ȱȱȱȱȱȱȱĞǰȱȱȱȱȱ

¢ȱȱȱȱĴȱȱȱ¢ȱǯȱȱ

the mounting plate screws to 2.5 N·m (22 in. lb.).

Mounting

Plate

Screws

Figure 4. Throttle Plate Mounting Screws.

ȱȱȱĞȱȱ¡ȱȱȱȱ

the actuator reinstall as follows:

1. Disconnect linkage and remove the Digital Linear

Actuator (DLA) from the control assembly. See Figure 1.

2. ȱȱĞȱ¢ȱȱȱǯȱȱȱśǯ

3. ȱȱȱȱȱȱȱȱǯ

4. ȱȱȱĞȱȱȱǯȱȱȱȱ

Ğȱȱřȱȱǰȱ¢ȱȱǰȱ

ȱ¢ȱȱȱȱĞȱ¢¢ȱȱȱȱ

ȱ¢ȱȱȱǯȱȱȱȱĞȱȱȱ

¢ȱȱĚȱȱȱȱȱȱȱȱȱȱ

mounting holes.

NOTE: ȱȱȱȱȱĞȱĞȱȱȱȱ

contact with the keyway will damage the keyway or

the actuator.

śǯ ęȱȱȱ¢ȱȱ¢¢ȱȱȱǰȱ¢ȱ

ǰȱȱȱȱĞȱȱȱǯȱȱȱȱȱ

ȱȱȱȱȱȱǯȱȱȱĞȱȱ

ȱȱǰȱȱȱȱǯȱȱȱȱĞȱ

repeat the previous step.

6. Install DLA into the control assembly and connect

linkage. See Figure 1.