Instructions / Assembly

6
16. Attach the sprayer to the tractor hitch and connect
the wiring to the tractor battery. The red wire must
be connected to the positive post on the battery or to
the "HOT" connection on a tractor switch or ammeter.
The brown wire may be grounded or connected to the
negative battery post. See gures 9 and 10.
IMPORTANT: This sprayer should be connected to 12 volt
batteries only!
12. Insert a garden hose gasket into the swivel nut on the
bypass/return hose. Screw the nut onto the upper outlet
of the "Y" valve tting. Place the other end of the hose
down through the hole at the rear of the tank. See gure
8.
13. Insert a garden hose gasket into the swivel nut on the
boom connecting hose. Screw the nut onto the lower
outlet of the "Y" valve tting. See gure 8.
14. Slide the coiled hose clamp onto the spray gun hose.
Push the hose onto the hose adapter on the side of
the "T" tting as shown in gure 8. Tighten the clamp
around the hose and the adapter. Snap the spray gun
into the clips on the side of the tank.
15. Carefully screw the pressure gauge into the top of the
"T" tting. See gure 8.
FIGURE 8
DANGER! Never allow negative pin on plug
to come in contact with positive "hot" post
on battery. Fire or explosion may result!
FIGURE 10
FIGURE 9
BOOM CONNECTING HOSE
SPRAY
GUN
HOSE
PRESSURE
GAUGE
COILED
HOSE
CLAMP
BYPASS/RETURN HOSE
GARDEN
HOSE
GASKET
BROWN
IN LINE SWITCH
RED
QUICK COUPLER
BATTERY
+
RED
BROWN
PLUG
NEGATIVE PIN
12 VOLT TRACTOR BATTERY
POSITIVE
"HOT"
POST
+
NEGATIVE
POST
ENGLISH