Instructions / Assembly
5
9. Assemble the boom mount bracket to the rear of the
hitch tubes using two 5/16" x 2" hex bolts and 5/16"
nylock nuts. See gure 5.
10. Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts, tooth lock washers
(between the bar and bracket), 5/16" at washers and
knobs. The boom connecting hose should extend upward.
See gure 6.
NOTE: Make sure the nozzle openings face straight
down when the boom bars are in the horizontal operating
position.
FIGURE 7 VIEWED FROM REAR
FIGURE 6
FIGURE 5
11. Assemble the large and small spray gun clips to the
side of the tank using two #10 x 1/2" screws and #10
lock washers. See gure 7.
5/16" NYLOCK NUT
BOOM MOUNT
BRACKET
5/16" x 2"
HEX BOLT
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
#10 x 1/2"
SCREW
#10 LOCK
WASHER
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" WASHER
WASHER
(TOOTH LOCK)
BOOM BAR
BOOM CONNECTING HOSE
7. At this time tighten all bolts starting with the bolts in
gure 2, then the bolts in gure 3.
8. Install the drain in the rear of the tank as shown in gure
4. Place a 3/4" garden hose gasket onto the drain body
and insert the drain body out through the hole in rear of
the tank. Outside the tank, assemble the nylon washer,
then the nylon nut onto the drain body. Tighten the nut
securely enough to prevent leaking, being careful not
to damage the plastic parts. Place the O-ring inside the
nylon cap and screw the cap onto the end of the drain
body. See gure 4.
FIGURE 4
NYLON CAP
DRAIN BODY
HOSE
GASKET
NYLON
WASHER
NYLON NUT
O-RING
ENGLISH