Instructions / Assembly

4
ASSEMBLY INSTRUCTIONS
FIGURE 2
5. Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts and 5/16" nylock nuts. Do not
tighten yet. See gure 3.
6. Assemble the hitch brackets to the hitch arms using two
5/16" x 2" hex bolts and 5/16" nylock nuts. Position each
bolt behind one of the cross bolts in the hitch arms. Do
not tighten yet. See gure 3.
TOOLS REQUIRED FOR ASSEMBLY
(2) 1/2" Wrenches
(1) Screwdriver
(1) Pliers
(1) Hammer
4. Assemble a hitch arm to the inside of a frame tube
underneath the tank. Use two 5/16" x 2" hex bolts and
5/16" nylock nuts as shown in gure 2. Do not tighten
yet. Repeat for other side.
1. Remove all items from carton and lay out as shown on
pages 2 and 3.
2. Assemble the axle through the large holes in the frame
tubes. If the axle will not t, slightly loosen the bolts in
the frame tubes to align the holes. Retighten the bolts
after assembling axle. See gure 1.
3. Assemble a 1/2" at washer, a spacer, a second 1/2"
at washer, a wheel (valve stem facing out) and a third
1/2" at washer onto the axle. Lightly tap a palnut onto
the end of the axle. Repeat on other end of axle. See
gure 1.
FIGURE 3
FIGURE 1
1/2" FLAT
WASHER
SPACER
PALNUT
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
HITCH ARM
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
5/16" x 1-1/4"
HEX BOLT
5/16" NYLOCK NUT
ENGLISH