Owner manual

Caterpillar Enclosed CVT Addendum

6j. Seat the opening at the transfer case end

of the back plate over the boss that sur-

rounds the input shaft. See Figure 2b.22.

• If the opening in the back plate sill not align with

the boss on the transfer case, DO NOT attempt

to draw the two together by tightening the

screws.

• If necessary, loosen the screws that hold the

transfer case brackets to the engine and transfer

case tray using a pair of 1/2” wrenches.

6k. Once the back plate is properly aligned on

engine and transfer case, tighten all the

screws. See Figure 2b.23.

6l. Re-mount the starter motor.

See Figure 2b.24.

• Apply releasable thread-locking compound such

as Loctite 242® (blue) to the screws.

• Install the screws and lock-washers that hold the

starter to the engine plate, tightening the screws

to a torque of 22-25 ft-lbs (30-34 N-m).

• Check electrical connections and insulating

boots on the starter motor and solenoid.

7. CVT Installation

7a. Prepare the CVT for installation:

• Clean the shafts and the surrounding area

before installing the CVT.

Figure 2b.22

Transfer case

Back plate

Mounting boss

Figure 2b.23

Figure 2b.24

Screws

Starter motor