Product Manual

7Section 2 — ASSembly & Set-Up
2. Using the hex washer screws (a), install the chute
rotation control assembly. See Figure 2-12.
(a)
(a)
(a)
(a)
Figure 2-12
3. Remove the screw (a) and hex lock nut (b) from
the universal joint. See Figure 2-13.
(a)
(b)
Figure 2-13
NOTE: Make sure the chute is facing forward
when installing the universal joint.
4. Install the universal joint on the end of the
chute rod as shown in Figure 2-13.
NOTE: Be sure the holes in the universal joint
line up with the holes in the chute rod. You
may have to activate the trigger to allow you
to line up the holes.
5. Secure the universal joint with the hex lock
nut (b) and screw (a) removed in Step 3. See
Figure 2-13.
6. Slide the rubber bellow over the universal
joint. See Figure 2-14.
Figure 2-14
STOP
STOP! Continue to Installing the Recoil
Starter Handle onto the Upper Handle
(page 7).
Installing the Chute Rotation Control (If
Equipped)
NOTE: Refer to Figure 2-1 and continue to your
applicable chute style.
Upper Crank Chute
If your snow blower comes equipped with an
Upper Crank Chute. the chute rotation assembly
will come preinstalled on the snow blower.
STOP
STOP! Continue to Installing the Recoil
Starter Handle onto the Upper Handle
(page 7).
Lower 2-Way Chute
1. Remove the hex lock nut (a) and machine
screw (b) from the chute rotation control
assembly. See Inset I in Figure 2-10.
(a)
(a)
(b)
(b)
I
II
Figure 2-10
2. Place the chute rotation control assembly
onto the chute rotation rod, align the holes
and secure with the hex lock nut (a) and
machine screw (b) removed in Step 1. See
Inset II in Figure 2-10.
STOP
STOP! Continue to Installing the Recoil
Starter Handle onto the Upper Handle
(page 7).
Upper 2-Way Chute
1. Remove the hex washer screws (a) from the
back of the handle (two on each side). See
Figure 2-11.
(a)
(a) (a)
(a)
Figure 2-11
Installing the Recoil Starter Handle onto
the Upper Handle
1. Remove the eye bolt and handle knob from
the manual bag.
2. Place the eye bolt (a) and handle knob (b)
on the upper handle as shown in Inset I in
Figure 2-15. Do not fully tighten the hardware
until instructed to do so.
(b)
(a)
I
II
Figure 2-15
NOTE: The opening of the eye bolt (a) should
face toward the back of the snow blower.
3. Slowly pull the recoil starter handle up
towards the eye bolt (a).
4. Slip the recoil starter rope into the eye bolt (a)
from the back of the snow blower. See Inset II
in Figure 2-15.
5. Securely tighten the eye bolt (a) and handle
knob (b).
Installing the Drift Cutters
(If Equipped)
1. Remove the carriage bolts (a) and flange lock
nuts (b) from the drift cutters.
2. Install the drift cutters and secure with the
carriage bolts (a) and flange lock nuts (b)
removed in Step 1. See Figure 2-16.
(b)
(a)
Figure 2-16
Adding Fuel & Oil
Refer to the Engine Operator’s Manual for
information on adding fuel and oil.