Use and Care Manual

Controls and Features
4
7
Fuel Shut-Off Control
If equipped, is used for controlling the flow of
fuel between usage and transport/storage.
Oil Drain
Removing the oil drain plug will drain the oil
from the engine.
Oil Fill/Dipstick
Remove the oil cap to check the oil level and
add oil.
Factory Fill & Drain*
DO NOT USE - This port is used by the
manufacturing factory only.
Fuel Fill
Remove the cap to add fuel.
Speed Control Knob
Change engine speed setting based on required
performance.
On/Off Key
Two-position key to be used to power the
Electronic Fuel Injection (EFI) system when
turned to the ON position. Rotate to “ON”
position and pull recoil handle to start engine.
Ready Light
Green power indicator light (ready light) will
illuminate when power is supplied to the
Electronic Fuel Injection (EFI) system and the
engine is ready to start.
Service Light
Used to determine engine system fault and
provide diagnostic information.
Battery Box
Contains the Electronic Fuel Injection (EFI)
system battery.
The battery must have enough charge to power
the Electronic Fuel Injection (EFI) system before
starting the engine. If necessary, charge battery
before operation. Refer to Charging The Battery
in the Maintenance Section of this Manual.
NOTE: Battery supplies power to the EFI system
only. The battery is not used to start the engine.
Recoil Starter Handle
This handle is used to manually start the engine.
Electric Starter Inlet (If Equipped)
Requires the use of a three-prong outdoor
extension cord and a 120V power source/wall
outlet.
Electric Starter Button (If Equipped)
Pressing the button on the top of the electric
starter switch engages the engine’s electric
starter when plugged into a 120V power source.
Speed Control
Knob
Muffler
Electric
Starter
Button
Oil Drain
Fuel Fill
Oil Fill/Dipstick
Ready Light
Battery Box
On/Off Key
Service Light
Recoil Starter Handle
Electric
Starter
Inlet
Factory Fill
& Drain*
Battery
Charger
Figure 4-1