User manual

Assembly & Set-Up
3
5
Contents of Carton
• Chipper/Shredder Vacuum (1) • Operator’s Manual (1) • Engine Operator’s Manual (1)
• Upper and Lower Handle (1) • Hose Assembly (1) • Safety Glasses (1)
• Bag (1) • Bottle of Oil (1)
• Hose Extension (1)
Assembly
NOTE: This unit is shipped without gasoline or oil in
the engine. Fill up gasoline and oil as instructed in
the accompanying engine manual BEFORE operating
your chipper shredder vacuum.
Handle
1. Remove the hairpin clips from the handle
brackets and the carriage screws and wing
nuts from the lower handle.
a. Place the bottom holes in lower handle
over the pins on the handle brackets
and secure with hairpin clips. See
Figure 3-1.
a
b
b
Figure 3-1
b. Insert carriage screws through upper
hole in lower handle from the inside
and secure with wing nuts. See Figure
3-1.
3. Unfold the upper handle until it aligns with
thelower handle. Make sure the rope guide is
on the right side of upper handle. See Figure
3-2a.
ab
Figure 3-2
IMPORTANT: Make sure the cables are routed
outside the lower handle. Also, do not crimp
the cables while lifting up the handles.
4. Secure the two handles by tightening the star
knobs (carriage bolts must be seated properly
into the handle). See Figure 3-2b.
5. Pull the two cable ties attached to the cables
tight approximately 8 inches from each cable
end and place the cables into the cable guide.
6. Loosen the wing nut that secures the rope
guide to the right side of upper handle.
a. Slowly pull starter rope out of engine.
b. Slip the starter rope into the rope
guide. See Figure 3-3.
a
b
c
Figure 3-3
c. Tighten the wing nut.
Hose Assembly
1. Slide hose adapter of hose assembly into the
base adapter located on the left front of the
chipper shredder vacuum. See Figure 3-4a.
a
b
Align pin
with this
hole.
Figure 3-4
2. Pull spring loaded pin out on the base and
align pin with the first hole (closest to the end
of the tube) in the hose adapter. See Figure
3-4b.
3. Release the pin to lock the hose in place.
4. Lay hose tubing in curved end of hose handle
next to chipper chute and into hose cradle.
See Figure 3-5a & b.
b
a
c
Figure 3-5
5. Snap the hose handle first into the upper hose
handle bracket and then into the lower hose
handle bracket. See Figure 3-5c.