Full Product Manual

6 Section 2 — ASSembly & Set-Up
3. Align the holes in the chute base with the
three tabs (b) in the lower chute as shown in
Figure 2-8, Inset I. Secure the chute base with
the hex washer screws (a) removed in Step 2.
See Figure 2-8.
(a)
(a)
(a)
I
(b)
(b)
(b)
Figure 2-8
STOP
STOP! Continue to Installing the Recoil
Starter Handle onto the Upper Handle
(page 7).
Lower 2-Way Chute, Upper 2-Way Chute & Upper
Crank Chute
1. If not already done, install the chute plug (a) onto
the chute (b) as shown in Figure 2-9. Be certain
that the plug is aligned in the channel on the
chute and that the tabs snap into place.
(a)
(b)
Figure 2-9
2. Remove the hex washer screws (a) in the
chute base. See Figure 2-7.
3. Align the holes in the chute base with the
three tabs (b) in the lower chute as shown in
Figure 2-8, Inset I. Secure the chute base with
the hex washer screws (a) removed in Step 2.
See Figure 2-8.
STOP
STOP! Continue to Installing the Chute
Rotation Control (page 7).
4. On models with adjustable handles, place the
handle in the desired position and then install
wing knobs (a) and carriage bolts (b) in the
appropriate hole and secure the handle. See
Figure 2-5.
(a)
(b)
Figure 2-5
Chute Assembly Options
NOTE: Refer to Figure 2-1 and continue to your
applicable chute style on pages 6-7.
E-Z Chute™
1. Place the chute handle (a) onto the chute
(b) as shown in Figure 2-6. Be certain that the
handle is aligned in the channel on the chute
and the tabs snap into place.
(a)
(a)
(b)
(b)
Figure 2-6
2. Remove the hex washer screws (a) in the
chute base. See Figure 2-7.
(a)
(a)
(a)
Figure 2-7
Tools Required
• Adjustable Wrench or Socket Set
• Phillips Head Screwdriver
Handle Assembly
1. Remove the wing knob (a) and carriage bolt
(b) from the top of the lower handle. See
Figure 2-2. It is not necessary to remove the
shoulder screw and flange lock nut below
the wing knob and carriage bolt unless the
handle is loose in the carton.
(a)
(b)
(a)
(b)
Figure 2-2
2. Pivot the upper handle into the operating
position. Be sure not to pinch any of the cables
in the process. See Figure 2-3.
(a)
(a)
(b)
(b)
Figure 2-3
3. See Figure 2-4. On models with an adjustable
handle (a), proceed with
Step 4. On models without adjustable handle
(b), tighten the hardware removed in Step 1 to
secure the handle in place. See Figure 2-3.
For models without an adjustable handle (b),
continue to Installing the Chute.
(b)
(a)
Adjustable
Handle
Non-Adjustable
Handle
Figure 2-4