Use and Care Manual

8 Section 3— ASSembly & Set-Up
6. The outer front clips attach to the front
fenders near the wheels. See Figure 3-14.
Figure 3-14
7. A bungee strap runs over the front of the
hood. This strap is used to tighten the snow
cab around the hood and prevent snow
from entering the cab. The hooks of the
strap are hooked onto the hood near the
front wheels. See Figure 3-15.
Figure 3-15
8. Unzip the cab door and locate the five
straps inside the cab. There is one in the
front (near the hood) and a four along the
top. Snap the ends of each strap together
and then tighten them securely. See
Figure 3-16.
Figure 3-16
9. A pair of magnets are on the bottom
section of each side of the floor boards.
These magnets help hold the lower
portion of the snow cab against the
floorboards. See Figure 3-17.
Figure 3-17
10. Secure the two velcro tabs on the back
corners of the snow cab to ensure a tight
fit. See Figure 3-18.
Figure 3-18
11. If your tractor has a snow thrower
installed, the chute directional control can
be positioned or routed inside the cab
through the zippered opening on the left
side of the cab. See Figure 3-19.
Figure 3-19
12. The lift handle and trigger control can be
accessed by unzipping the right side of
the snow cab. See Figure 3-20.
Figure 3-20
NOTE: These zippers can also be opened
for air circulation.