Operator's Manual

4 Section 2 — inStallation
42”, 50” & 54” Stamped Deck Striper Kit - Model
19A70060OEM
Model 19A70060OEM striper kit is designed for use with
select Residential Zero Turn (RZT) mowers. Refer to your RZT’s
Operator’s Manual to assure compatibility.
Carton Contents - Model 19A70060OEM
Before beginning installation, remove all parts from the carton
to make sure everything is present. Carton contents are listed
below. Part numbers are shown in parentheses. See Figure 1-4.
1. Four Carriage Bolts, ⁄-18 x 1.00 (710-0276)
2. One Roller Pin, ⁄ x 27.75 (711- 0566 4)
3. Four Lock Nuts, ⁄-18 (712-04063)
4. One Lock Nut, ⁄-13 (712-3083)
5. Four Rollers (731-05679B)
6. One Left Roller Bracket (789-02377)
7. One Right Roller Bracket (789-02378)
3
5
1
7
2
Figure 1-4
42” Stamped Deck Striper Kit Installation - Model
19A70060OEM
To install the Striper Kit on tractors equipped with a 42” stamped
deck proceed as follows:
1. Use Figure 1-5 below to locate the proper mounting hole
locations on the Left and Right Roller Brackets (#6 & #7) for
your kit.
Figure 1-5
2. Install the Left and Right Roller Brackets (#6 & #7) to the
locations shown in Figure 1-6 on the Tractors deck with two
Carriage Bolts (#1) and two ⁄ Lock Nuts (#3) per side.
Figure 1-6
3. Align the four Rollers (#5) inside the brackets and slide the
Roller Pin (#2) through the center of the rollers and into the
mounting hole of the Right Roller Bracket (#7). See Figure
1-7.