Installation Sheet

Printed In USA
InstallatIon sheet
Striper Kit — 19A70047100
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 769-10197
April 7, 2015
With the roller support bracket installed, slide the roller pin
through the left side of the bracket, through the four roller pins
and out the other side of the bracket. Secure the pin and rollers
in place by inserting the hooked end of the pin in the appropriate
hole in the bracket and install the hex lock nut. See Figure 1-2.
Figure 1-2
Set-Up
The roller can be adjusted to two different heights. To change
the height of the striper kit, remove the hex lock nut and slide
the pin out far enough to move it into the desired height setting
on the right side of the bracket. Secure the hooked end of the pin
and install the hex lock nut to lock into position.
Figure 1-3
NOTE: Deck wheels may need adjusted for maximum
striping performance. See your tractor’s Operator Manual
for instructions on adjusting the deck wheels.
Model 19A70047100 striper kit is designed for use with select
Residential Zero Turn (RZT) mowers. Refer to your RZT’s
Operator’s Manual to assure compatibility.
Carton Contents
Before beginning installation, remove all parts from the carton
to make sure everything is present. Carton contents are listed
below. Part numbers are shown in parentheses.
• One Roller Support Bracket (703-09967)
• One Roller Pin (711-05664)
• Four Rollers (731-05679B)
• One Hardware Pack
• Four ⁄-16 x .75 Carriage Bolts (710-3178)
• Four ⁄-16 Flange Lock Nuts (712-04065)
• One ⁄-13 Hex Lock Nut (712-3083)
Installation
Using the four carriage bolts and flange lock nuts, install the
roller support bracket onto the back of the deck as shown in
Figure 1-1.
Figure 1-1