Warranty

16 Section 4 — ASSembly & inStAllAtion
7. Install the chute adapter onto the chute elbow by lining
up the tabs and sliding the adapter over the chute elbow,
as shown in Figure 4-30. Secure the chute adapter by
installing two 710-3013 hex screws into the holes shown
and secure with two 712-0442 cap lock nuts, included in
hardware pack 689-00337.
Figure 4-30
8. Install the upper chute tube over the chute tube extension,
as shown in Figure 4-31.
Figure 4-31
9. Secure the upper chute tube to the lower discharge chute
by stretching the rubber strap on the upper chute tube
downward and hooking it onto the pin on the lower chute
tube. See Figure 4-32.
Figure 4-32
10. With the bagger cover open, install the upper chute over
the chute adapter, and rest the top so that the chute
support sits in the upper chute groove. See Figure 4-33.
Note: Make sure to align the upper chute with the ridges
on the bagger support bracket, as shown in the inset of
Figure 4-33.
Figure 4-33