Warranty

10 Section 4 — ASSembly & inStAllAtion
Figure 4-10
13. Install a bagger support bracket on each side of the tractor,
using the same holes in which the screws in Step 1 were
removed. Mount each bracket to the tractor frame by
feeding a 710-1090 hex screw found in hardware pack 689-
00338 through the frame, then a 712-3010 hex nut. Tighten
the hex nuts at this time. See Figure 4-11.
Note: The hex screws can be fed outward through the
frame first, as shown in Figure 4-11, or inward through
the bagger support bracket first. This option is based on
preference. The 712-3010 hex nuts should be tightened
(against bumper if bolts are inside-out, or against bracket if
bolts are outside-in).
14. Install the bagger support frame onto the hex screws
installed in Step 11. Secure the brackets using a 712-3004A
flange lock nut from the same hardware pack. See Figure
4 -11.
Note: It might be easier during this mounting assembly
stage to leave the 712-3004A lock nuts only finger tight
to facilitate the remaining installation steps. You will be
instructed to tighten this hardware later in this manual.
Figure 4-11
9. Position the muffler and bumper shield into place on the
tractor, as shown in Figure 4-8.
Figure 4-8
10. Re-install the rear hitch plate removed earlier using
hardware from the pack 689-00343. See Figure 4-9.
11. Install the bumper over the muffler and bumper shield
held in place, and secure with the two remaining tap
screws removed in step 1. See Figure 4-9.
Figure 4-9
12. Secure the bumper to the muffler shield using four (4) 710-
04484 included in hardware pack 689-00343. See Figure
4-10.
Note: The four (4) 710-04484 hex screws mount in the two
corner holes on each corner of the bumper. See Figure 4-10.